PT. MIMAKI INDONESIA

When starting RLP5 after License activation, "Re-activation needed" is shown and RLP5 will not run

  • Please check the following contents

Countermeasures:

[1] License is not activated.

Follow RLP5 Operation manual to deactivate the License and then activate the License again.
* Unchecking “Delete the serial key information” before deactivation of License saves
the trouble of entering license key when activating the License again.



[2] This error may occur when installing security software after installing the RLP5.
In the case of RLP5 Ver.2.20 or earlier, it is not possible to use RLP5 and security
software at the same time. Upgrading to RLP5 Ver.2.30 or later is recommended.

[How to upgrade RLP5 to Ver.2.30 or later]
(1) Uninstall the current version of RLP5 (Ver.2.20 or earlier)
Please see RLP5 Installation Guide for uninstall instructions
* All job data will be deleted during uninstallation.
(2) Install RLP5 to Ver.2.30 or later as a new installation
* Removal of the security software is not needed.


Return to Content

PAGETOP